The Varian Cary 300 UV/Vis Spectrophotometer with Cary Dual Cell Peltier Accessory is used worldwide for routine analysis and research. The Cary 300 is controlled by the new Cary WinUV software. This Windows based software features a modular design which makes it easy to use. The instrument is shipped with liquid sample holders and of course it can be fitted with a wide range of accessories to provide extra capabilities.
Features:
- Wavelength accuracy (nm) – ± 0.2
- Wavelength range (nm) – 190 – 900
- Pre-monochromator – extends the working range of the Cary 300 past 5 absorbance units by lowering the stray light levels. Dilution of a sample, to bring it into a range that the spectrophotometer can measure, is therefore not required
- Quartz overcoating – protects the optics from the environment and allows cleaning without damage to their reflective surface
- Sealed optics – prevents exposure to corrosive environments
- Variable slits – allow optimum control over data resolution. The spectral bandwidth can be set down to 0.2 nm. (Many instruments on the market are limited to a fixed SBW of 2 nm)
- Phase locked wavelength drive – prevents peak shifts and peak suppression at high scan speeds.
- Double choppers – ensure that the sample and reference beam strike the detector at the same point, removing any errors due to non uniformity of the detector
- The large sample compartment – gives you more flexibility in sample size
- Centralized accessory control – all accessories are centrally controlled by the Accessory Controller, built into the Cary instrument. Instead of each accessory having their own electronics, the Accessory Controller provides the interface between the Cary software and the accessories. If your custom-built accessories will fit into the Cary instrument, you can use the Accessory Controller to control them. Even external accessories, such as titrators, lasers and pH meters can be controlled.
The Peltier cell holder controls sample temperature for a single sample and reference when performing UV-Vis measurements. The temperature of each cell holder can be independently regulated or used at a single temperature with the Cary UV-Vis and UV-Vis-NIR spectrophotometers.
The Peltier cell holder is automatically controlled by the UV-Vis spectrophotometer software and can be used together with the Cary temperature probe to monitor sample temperature. The cell holder is mounted onto the standard cell holder base supplied with the spectrophotometer.
Features:
- Control the liquid sample temperature while performing UV-Vis spectroscopy measurements
- Stable, static temperature control between 0–100 °C
- A water circulating system is required, and can be provided with the Peltier cell holder